Art in wood
From the conversation to installation
Five steps. First the place and the conversation, then a drawing and a price in writing. The board is chosen before the saw enters the wood.
From the frame to the work.
Timber frames
Walls and floors framed in wood so that what carries the house stays visible. The section is chosen for the span, the snow and the wind.
Cladding and insulation
Cladding and insulation for a timber house that is to remain, once the heat should stop leaving. A thermal upgrade that leaves the board, the corner and the eaves in sight.
Timber terraces
The deck beside the house. Boards, joists and a fall set so water leaves, and does not stay underfoot.
Shelters and canopies
A roof over the entrance, the firewood, or a place to work outside. A light structure, reckoned for snow.
Carport
A timber roof for a car, fitted to the house that already stands. Posts and beams stay visible.
Loft interiors
A finish in which wood meets stone and metal. A wall, a top, stairs or a shelf. Each material stays itself.
Art and joinery
Beside the structure come the works: a table from one board, furniture for one room, stairs read as sculpture, a form taken from the trunk.
- 1
Conversation
The conversation starts with the place: the measurements, the light, and how the piece will be used. Photographs, references, a budget and a date all help. None of them is required before you write.
- 2
Drawing and a written quote
After the conversation there is a drawing and a price in writing, before the first shaving.
- 3
Choosing the board
Before any cutting, there are photographs of the boards. The choice is a particular figure, knot and edge, not a species in the abstract. Only the chosen piece goes to the bench.
- 4
Making
The piece is made in the workshop in Poland. Along the way there are photographs of the stages: after assembly, before the finish, and when something needs a decision. Fitting on site does not replace that correspondence.
- 5
Delivery and fitting
Delivery and setting in place, when the project needs them. The piece comes with a short note on care: what to renew the oil with, and how to treat wood that stands in the rain.
What to have ready before the conversation
If it is to hand.
- Photographs of the place where the piece will stand, in daylight.
- Measurements, even rough ones: width, height, the way through.
- References. A photograph, a drawing, or a description.
- A budget, even a range.
- A date, if it is tied to building work, a move, or a season.
The quote
There is no price list. The drawing and the figure are set down after the conversation, for this one piece.
Every project starts with a conversation.
The piece and the place. The reply comes in writing.